Showtec DMX Merge 2-way DMX merge The Showtec DMX Merge allows you to combine two DMX controllers to one DMX line or to use a second desk as back-up desk.

The unit has 3 modes:
1) HTP (High Take Precedence) In this case you can use two similar desks with the same
addressing on one line. The DMX channel with the highest value has priority.

2) Back-up mode. The unit is connected to two DMX desks. Channel A has priority.
Once channel A fails or has no DMX channel B takes over the show.

3) Merge mode. Two desks can be merged on one line. E.g. you can run a scene setter
and DMX operator on one line. The Scene Setter will operate on channel 1-96 and the
DMX Operator will have the channels 97 and higher.
These positions can be freely addressed by the dip-switches. Voltage: 230V
Power Requirement: DC 9V, 300 mA Min.
(AC/DC adapter included)
DMX Input: two 3-pin
XLR male sockets on the front panel
Extra: two 3-pin
XLR male sockets on the rear panel
DMX output: two 3-pin
XLR female sockets on the front panel
Extra one 3-pin XLR
female sockets on the rear panel
Dimensions: 483 x 73 x 45 mm (LxWxH)
Weight: 1,15 kg